Marion Wan
- Total activity 325
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 165
Articles
Recent activity by Marion Wan-
External laser spot split
Please refer to Unusual laser spot>>.
-
Laser beam hitting the cathode metal ring
Rest assured that this is normal. If the laser power seems to be weakening, see Weakened laser performance>> to troubleshoot.
-
Unstable laser beam in laser tube
If the laser seems to be wobbling in the laser tube, check that the power is set to no lower than 20%. This happens when the laser is not fully fired under low power settings. If the power settin...
-
Unaligned Laser
See the manual of the engraver to troubleshoot or you can refer to the articles to align the laser beam. How do I align mirror 1>> How do I align mirror 2>> How do I align mirror 3>>
-
Reduced laser power
If the laser power is always weak or if it is now impossible to achieve the same engraving effect using the previously set parameters, see Weakened laser performance to troubleshoot. If the laser...
-
Problems with cut lines
If the line is too thick Check the focal length with the provided focal length ruler. Correct as needed. Check that the light at the laser head is emitted from the center of the nozzle. You can re...
-
Line too thick
1. Check the focal length with the provided focal length ruler. Correct as needed. 2. Check that the light at the laser head is emitted from the center of the nozzle. You can refer to How do I alig...
-
Double line when cutting or engraving
1. First, confirm that the laser spot at the 3rd mirror is right following Unusual laser spot>>. Correct as needed. 2. If the laser spot is right at the 3rd mirror, check whether the focal lens is ...
-
Pattern distortion
1. Check whether the mirrors are loose, tighten them if so. 2. Check the carving speed. Set it over 150. 3. Open the software and adjust the PWM for the X-axis motor (as shown). Access "Vendor pa...
-
Pattern slanted towards one side
Open the software and adjust the PWM for the X-axis motor (as shown). Access "Vendor param" (password: rd88888). Click "Motor". Sequentially click "X", "Y", "Z" (if applicable), and "U"(if applica...