Marion Wan
- Total activity 329
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 165
Articles
Recent activity by Marion Wan-
Pinkish or purple-ish pictures
If you are using RDWorks, use the camera tuning function to modify the parameters of the camera (as shown). If you are using Lightburn on a Windows system, such problems can be solved by adjust...
-
Distorted camera picture(s)
Import the camera para in RDWorks. See Camera Calibration Guide in Lightburn.
-
Both X-axis and Y-axis remains non-responsive upon booting up
Check whether the light strip will light up when the engrave is energized. If the light is not lighting up, refer to Engraver not turning on>>. If the light does light up as expected. Check whet...
-
Laser head not moving along the Y-axis after powering on (X-axis normal)
If LED3 stays on all the time, fix the Y-axis limit (as shown) by gently tapping or replacing it. If the laser head won’t return to its origin along the Y-axis after being powered up. First, ch...
-
Laser head not moving along the X-axis after powering on (Y-axis normal)
If the laser head won’t return to its origin along the X-axis after being powered up. Remove the glass cover on the left side of the engraver and then remove the metal plate above the mainboard. C...
-
Laser head slowly moving in the opposite direction after powering up
In most cases, this might be caused by a faulty limit switch. Troubleshoot by the steps below. Remove the glass cover on the left side of the engraver. Remove the metal plate on top of the main bo...
-
X and Y axes non-responsive, button glowing green after 1 minute
In most cases, this might be caused by a faulty motor driver board. Troubleshoot by the steps below. Remove the bottom plate (as shown). Check the status of the indicator light on the motor driv...
-
Laser head not retracting after returning to the origin (no noise)
If a noise is heard when the laser head reaches the highest point along the Z-axis, refer to Problems with Z axis>>.
-
External axial fan not working
Check whether the fan starts to beep when it is energized. If not, make sure the sockets have power, or replace the external axial fan. If the fan starts to beep when it is energized. Repair t...
-
Weird X/Y axis movements
In most cases, weird X/Y axis movements might be caused by wrongly set parameters. You can easily solve this by re-importing the parameters of the mainboard (The file can be found in the U disk tha...