Joanna
- Total activity 14
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 8
Articles
Recent activity by Joanna-
No response upon booting up\The protective cover lights up red. (Split Fiber Laser Marker)
First, make sure you are booting up the laser marker following the right procedures: Connect the power cable to your machine, and then to a 3-prong socket, which must have a working ground wire. ...
-
Focus red dots not lit
If only one of them is lit and the other is not, replace them with new, identical ones. If both are not lit, Check that their power button is activated. If so, remove the housing of the Galvo ...
-
Laser source not energized (Split Fiber Laser Marker)
If you have pressed the reset button and the laser source is not making any sound, the problem might be with any of the following: 24V/48V laser source power supply Power button laser source Use...
-
Galvo head not energized (Split Fiber Laser Marker)
If you have turned the power key switch and the Galvo head is not making any sound, the problem might be with any of the following: 15V Galvo head power supply Power key switch Galvo head Use the...
-
No red dots (Split Laser Marker)
If the red dot guider is gone, check if the "red dot" parameter is set to 4. For LightBurn users, enable "blanking". If the red dot is still not showing up, check the input voltage of the red lig...
-
Focus red light dots won't merge
First, use the height adjustment knob to lower or raise the Galvo lens head to the correct focal height. Loosen the setscrews of the red light guiders. (as shown) Adjust their angle to...