Marion Wan
- Total activity 325
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 165
Articles
Recent activity by Marion Wan-
Laser beam fired during framing or when laser head is moving between patterns
1. Open RDWorks. 2. Access the user parameter interface. 3. Check that “Go scale mode” is set to “Close laser”(as shown). If that parameter has been rightly set all the time Initiate framing again...
-
Ammeter reading over 8 mA despite the power settings
In such a case, measure the voltage between the IN and GND terminals of the laser power supply across different power settings. 1. Open the cover of the laser power supply (refer to the video). 2...
-
Low ammeter readings despite different power settings
Turn the knob on the ammeter to its maximum and test. If the problem persists, proceed with the following steps. 1. Press the test button and check the reading on the LCD, the normal reading should...
-
Purplish laser beam
1. Press the test button on the laser power supply. 2. Check the status of the laser tube and the ammeter. If the laser beam still appears purplish inside the laser tube and the ammeter reads 8 mA...
-
Whitish laser beam
This happens when the gas charge inside the laser tube is depleting, which requires the replacement of the laser tube. One way to avoid this and extend the service life of your laser tube is to reg...
-
Reddish laser beam
This happens when the laser tube has a fracture and the air gets inside the laser tube, which gives the laser beam a reddish appearance. Replace the laser tube with a new, identical one if in such ...
-
Split/Deviated laser beam
When the laser beam appears split inside the laser tube, the laser tube is faulty. Replace it with a new, identical one. When the laser beam seems to be hitting the anode metal ring (anode electrod...
-
Laser beam instability in the laser tube
When the laser seems to be wobbling in the laser tube, check that the power is set to no lower than 20%. This happens when the laser is not fully fired under low power settings. When the power sett...
-
USB connection failure
When your control computer cannot be connected to the machine through LightBurn, make sure your LightBurn license is compatible with the DSP type of machine (if it doesn't support DSP, go to LightB...
-
Ethernet connection failure
Make sure: The IP settings are correct. The machine IP address is consistent with the software IP. The first three digits of the computer IP are the same as the machine’s and the last digit is di...