1. Troubleshooting
2. Accessories

Overview Below is a brief guide on the specified topics. For comprehensive details, please refer to the individual manuals for each chiller. Applicable Chiller Types CW-5200 CW-5201 CW-5202 Adjus...

1. Troubleshooting
2. Fiber

Make sure your laser marker is correctly grounded and free from any static charge disturbance. Check if the Galvo head is making a constant buzzing sound. If so, then the problem could be caused b...

1. Troubleshooting
2. K40

  Adjust both the maximum and minimum power to 100%. Turn the knob on the ammeter to its maximum. If no laser is being fired, check whether the "water protection" on the  LCD reads "on". If it re...

1. Troubleshooting
2. Fiber

If this happens a lot and can only be solved by rebooting, Connect the data cable to the port on the mainboard. Test the robustness of the software again.           If the software runs stably, ...

1. Troubleshooting
2. K40

  Press the test button. Check if the LCD of the laser power supply is lit. If not, troubleshoot it following LCD not lit>>. If the LCD is lit, Press the test button. Go check if "water protec...

1. Troubleshooting
2. Fiber

Adjust the "Port Settings (F3)“ in your control software. Change it from “laser ready” to "null".     

1. Troubleshooting
2. K40

  Adjust the "layer setting". Set the "overscanning" to about 8%.   

1. Troubleshooting
2. Fiber

Modify the "Door IO" and "Laser Ready IO"    

1. Troubleshooting
2. K40

  Remove the motor drive plugs and try moving the gantry. If it can move smoothly, there is nothing wrong with the motor or the gantry. If you have encountered damping along the range of movement,...

1. Troubleshooting
2. K40

  Please follow the steps below. Turn the potentiometers on the ammeter to its maximum. Press the test button on the ammeter. Check the reading on the ammeter and the laser beam inside the laser t...